1. Login to a computer using your ACE ID.
2. Insert a SD card flashdrive
3. Open the Green Cura software |
4. Use the toolbar on the left to move, rotate, or scale your model.
5. Use the toolbar on the right to create your print settings: ✱ Select the Printer you will use. ✱ Select the PLA (Village Plastics) material. ✱ Select the Profile you like. ✱ Select the Infill (density). ✱ Select Generate Supports if your model has overhangs. |
6. At the bottom right, note the estimated time and weight on your 3D print slip. 7. Save the file to your SD card. 8. Magnet your print slip to the front of the printer you are using. |
1. Turn on your 3D Printer, 2. Click the Front Button for the Main Menu. |
3. Hang your filament spool on the bar hanging off the right side of the printer. 4. Feed the filament end through the tube, and down through the top of the crossbars. 5. Loosen the locking guide where the filament enters. 6. Click the button to start purging filament. 7. Once the purging is finished, click Continue. |
8. From the Main Menu, select Print from Media at the bottom 9. Select Print. It can take several minutes to warm up and start printing. 10. Keep watch for the first few minutes in case any errors occur. 11. When your print is done and cooled down, |